FISHER AND PAYKEL Fridge Filter for External use. Model number RX611DUX1 which is compatible version

 This is for external compatible water filters with 1/4" pushfit connections

 You are buying very good quality compatible filters with push-fit connections.

 External inline refrigerator water filter is a replacement cartridge for refrigerators that have externally fitted cartridges replaces :

 Omnipure

 - K5520-BB

 - K2540-JJ

 - K2533-JJ

 - K2520-JJ

 External In-Line Water Filters

Features:

 Reduction filter works by chemical and mechanical means

 ?This Fridge Water Filter is designed to fit into FISHER AND PAYKEL side by side fridges that have externally fitted cartridges

 Delivers clean, clear water for great tasting

 Effectively reduce cysts, chlorine taste and bad odour

 Tested and used material according NSF International against NSF/ANSI Standards 42 for the reduction of chlorine taste and odour.

 In order to keep your filter working at its optimum, fridge manufacturers generally recommend replacement of fridge water filters every 6 months, or when the "change filter" light comes on or notice a decrease in flow of water..

Fridge Water Filter Spec:
Installation and replacement procedure for the (DA2010CB)H00608323485Afridge water filter:

1. Find isolation valve which will be located somewhere on the water supply line to the fridge. Turn it off and to depressurise the system draw a large glass of water from the water outlet at the fridge.

2. . Have a bucket and towel ready as there will be a small spillage of water during this process. Remove the old filter by depressing the locking collar at each end of the filter with your thumb nail (or similar) and at the same time pull out the water supply line. Discard the old filter.

3. Take the new filter, making sure the flow direction is correct and insert the inlet side only, the line will go in approx 5 10mm and you will feel it hit home.

4. Placing the filter in the bucket, turn on the water supply and allow about 5 litres of water to flow through the filter and into the bucket. This will remove any loose carbon fines. Turn off the water supply and connect the line that feeds into the fridge. Turn on the water supply and run approx 2 litres through the system.

5. Complete the Replacement Due sticker and place in a visible area inside the fridge door.